I am unsure what you are trying to infer?
Sent from my iPad using Tapatalk
An oldie, but a goodie
-
lee_enfield223
- .17 HMR
- Posts: 240
- Joined: Sun Nov 06, 2016 8:13 pm
- Favourite Cartridge: 223rem
- Location: sydney
Re: An oldie, but a goodie
If you are interested in buying the lathes at cambelltown tafe the DAEWOOS at the back were in really good condition when I did my apprenticeship there.
also the lathes close to the entrance got heaps of use ,but people being lazy hardly used the ones at the back !!!!!!!!
also the lathes close to the entrance got heaps of use ,but people being lazy hardly used the ones at the back !!!!!!!!
-
DSD
- .270 Winchester
- Posts: 1446
- Joined: Wed Jul 17, 2013 9:06 pm
- Favourite Cartridge: N/A
- Location: In hiding
Re: An oldie, but a goodie
It is funny they use the closest lathes but the furthest mills.
Distance between mills is a lot shorter though
Sent from my iPad using Tapatalk
Distance between mills is a lot shorter though
Sent from my iPad using Tapatalk